No products in the cart.
-
Vetus Plastic Hose Connection 90 degrees Bent Type ELB
Plastic hose connection bent 90 degrees for exhaust systems requiring tight turns.
€71.40 – €86.70Vetus Plastic Hose Connection 90 degrees Bent Type ELB
€71.40 – €86.70 -
Vetus Muffler Type DEMPMP
Its construction causes almost no resistance to the flow of the exhaust gases. Also, this muffler creates additional mixing of the water inside the exhaust line which results in even better noise reduction.
€88.40 – €257.55Vetus Muffler Type DEMPMP
€88.40 – €257.55 -
Vetus ANTISIPHON DEVISE WITH VALVE or HOSE 38MM
Suitable for a 38 mm hose. Also ideal for toilets or holding tanks that are installed below the waterline.
€83.70 -
Vetus Plastic Transom Exhaust Connection Type TC
Type TC is made of reinforced black synthetic material, with a decorative stainless steel band. The exhaust hose can be fitted directly to this transom connection.
€84.60 – €174.61Vetus Plastic Transom Exhaust Connection Type TC
€84.60 – €174.61 -
Vetus AIR VENT WITH VALVE or HOSE
Type V has a reliable pressure valve and is self-contained.
Type H has a hose connection to the outside of the hull. There is a constant bleed off of cooling water through this hose whilst the engine is running.
Both can be connected to hoses with internal diameters of ø 13, 19, 25 and 32 mm (½”, ¾”, 1” & 1¼” )
€87.55 – €107.95 -
Vetus ANTISIPHON DEVISE WITH PRESSURE VALVE or VENTILATION HOSE
Air vent suitable hoses with internal diameters of ø 13, 19, 25 and 32 mm (½ ”, ¾ ”, 1” & 1¼ ”)
€92.70 -
Vetus WATERLOCK GOOSENECK Type WLOCKLT
A Vetus gooseneck raises the exhaust hose above the waterline, so that water cannot backfill the exhaust system. After the engine is stopped, all cooling water in the exhaust hose will run to the lowest point of the system, which is where the waterlock should be situated.
€104.40 – €120.61Vetus WATERLOCK GOOSENECK Type WLOCKLT
€104.40 – €120.61 -
Vetus Water/Gas Mixer For Exhaust Hose
In some boats, the exhaust waterlock must be positioned so closely behind the engine’s exhaust manifold (this is especially true in the case of near-horizontal exhaust assemblies), that the injected cooling water does not always mix properly with the hot exhaust gases. This often results in the exhaust hose and/or the waterlock becoming overheated. Installation of a VETUS water mixer directly behind the exhaust manifold will overcome this problem.
€100.80 -
Vetus Sensor For Exhaust Temperature Alarm
Temperature Sensor for Vetus alarm instruments.
€101.15 -
Vetus WATERLOCK TYPE WLOCK LR
360° revolving inlet connection which facilitates the installation
€136.80Vetus WATERLOCK TYPE WLOCK LR
€136.80 -
Vetus PLASTIC WATERLOCK TYPE LP30
Waterlock suitable for exhaust hose with a 30 mm internal diameter.
€128.70